Freightliner air dryer purge valve

I have a constant air leak from the purge valve on the air dryer. The dryer cycles as it should per Meritor manual. After the system purges, there is a slow but steady air leak from the purge valve. Shut the truck off and it still leaks.

This purge valve would get stuck in the open position which then would not allow the system to build and hold air properly. Safety valve releases air. Nthe purge valve on the air dryer constantly sputters air. The check valve , turbo cut-off valve , heater, and purge valve assembly can all be serviced without disassembling the air dryer. We help you find the heavy duty truck parts that you need.

When the air fills up to 1psi the compressor kicks off like it should.

The problem is that the air dryer continues to leak air at the purge valve down to 1psi in about seconds and then it stops. I replaced the air dryer and the air governer and it continues to leak at the purge valve. The dry air is then moved out of the purge volume through the single check valve and out the delivery port to the first (supply) reservoir of the air system. The air dryer stays in the charge cycle until the air brake system pressure reaches the governor cutout setting. Could be the purge valve in the bottom of the air dryer.

A purge valve rebuild kit for AD-air dryers, includes everything needed to rebuild the purge kit of the AD-style air dryer. I can hear it a little while standing next to the air compressor with the hood open, but the noise is most pronounced when sitting in the cab or sleeper with the cab doors closed and seems to come from the air dryer. D) Drain cock and safety valve in first (supply) reservoir. Dryer purging ever seconds.

E) All air connections leading to and from the first (supply) reservoir. Includes Purge , Turbo Saver and One-Way Check Valve Assemblies. It was a bad air dryer purge valve like you said.

When rebuilding or replacing components of the air dryer use only genuine Bendix parts. Genuine Newstar replacement air dryer purge valve assembly. Click the button below to add the Wabco Meritor Style. American Truck Salvage, Inc.

Line between governor and dryer kinke plugge broken or frozen. Air dryer does not purge or exhaust air. Faulty heater or thermostat.

Check to make sure air flows through purge control line when compressor is unloaded. Clean or replace purge control line. Must utilize old bolt when rebuilding purge valve assembly. By all means, I would keep the dryer in the system.

The site may feel slow and unresponsive at times. As warm, moist air from the compressor hits the cool outer walls of the dryer , some moisture will condense on the walls and drain down into the purge - valve area. The air is then forced through a filter medium that will remove more moisture, and the treated air then exits the dryer through a one-way check valve.

Freightliner Columbia, 12. I think the filter in the air dryer is plugge that would cause the air to purge more often, but that does not explain the high pressure. USED AIR DRYER WITH BENDIX CHECK VALVE PN. Slightly oily discharge from the air dryer purge valve is normal. The discharge, or purge , event is triggered by the unloading signal from the governor.

If that line becomes blocked it may affect the air discharge cycles. Contaminants can become lodged in the purge valve , causing a constant leak. The purge valve can be easily replaced as well.

When your governor hits 1psi it purges to the air dryer to allow it to blow out moisture. The governor could be sticking on purge cycle allowing the air from governor to come out the dryer. Leakage at air dryer purge valve If purge area is damage replace air dryer. Also see PURGE CYCLE: Continuous leakage at purge valve below. Too long - consistently over seconds 1. Drain the air ,Two hoses to disconnect and four bolts.

The kit for the air dryer cost $90. It will bleed air out the purge valve if one of them is leaking. PSI and the cycle repeats.

If you have an un-loader valve problem then that could cause the air dryer to purge in the pattern you describe.

I would get the un-loader fixed to have the air system working properly. Every time the un-loader cycles the compressor off the air dryer is suppose to purge. Regular chassis maintenance is imperative to keeping your coach safe and reliable for years to come. Purge valve of air dryer leaking due to carbon and oil contamination. Purge cycle of air dryer is cut short due to high air consumption of vehicle.

Warm air recondenses in the cooler environment of the wet tank. There are 3truck air dryer valve suppliers, mainly located in Asia. The top supplying countries are China (Mainland), Turkey, and Hong Kong, which supply , , and of truck air dryer valve respectively.

Truck air dryer valve products are most popular in Eastern Europe, Mid East, and Africa. It is recommended that the vehicle be. The air dryer is designed to collect and remove air system contaminants in soli liqui and vapor form before they enter the brake system.

A-Line ABS Air Disc Brake Pad Kit Air Valve Alliance Alliance Slack Adjuster Automann Barksdale Bearing Cup Bendix Bolt Bracket Clamp Detroit Diesel Die-Cast Model Donaldson Driveline Equipment ESPAR exhaust clamp fender Filter FREIGHTLINER Fuel Filter Fuel Filter Kit Kawasaki Kit lamp LED Light Meritor Meritor Wabco Minimizer mirror New.